Jig mold inventory

Steve-O · Posted: Thu, Feb 15 2007 10:02 am Post subject:

I'm up for a jig pouring party or a jig tying party this weekend if anyone is interested.
_________________
You think THAT'S hard, try naming two cities in New Hampshire!

Steve-O · Posted: Fri, Feb 16 2007 11:59 am Post subject:

R&BCustomTackle wrote:

Well i guess this would be a good first post to the board so here goes a list of some of my molds.

Banana Head 1/8-1/2
Ultra Minnow 1/8-5/8
Round head no collar 1/4x8 weedless and non weedless

Bryon, these are the three I'm most interested in. But would like to take a look at others.
_________________
You think THAT'S hard, try naming two cities in New Hampshire!

R&BCustomTackle · Posted: Fri, Feb 16 2007 12:25 pm Post subject:

just sent ya a message Steve-O, and on the same note i have about a hundred of the bananna head that i have poured and powdercoated that i am not going to use, you are more than welcome to them. And it would be great to have a pouring and tying get together this weekend I am up for it lets get a few people together. And i have a new design i would like to test out for sandbass so maybe yall could give me your opinions

texascrappiefisherman · Posted: Fri, Feb 16 2007 06:18 pm Post subject:

It is supposed to be really windy tomorrow so I think pouring and tying is in order vs. fishing. I have several new molds from ebay. I'll bring them and my lead pot. Let me know where we're doin it.
_________________
Jerry Hamon
TPWD Angler Instructor
Van Alstyne, TX